Enigineering schematics after race change

[janusmarine]

Since I changed race on my character (Orcfroy) I have some trouble with a few schematics. I had to relearn engineering, which I've done, but I can't learn the schematics I knew before the race change. The schematics I knew from before simply don't show up at any of the trainers.

Hope some of you could look into this issue.

[Henhouse]

Well that's why we have this beginning and ending dialogue boxes when you switch races.

[janusmarine]

Hey Henhouse. I am aware that my professions will be reset, the problem is that I can't relearn some schematics. I.e. I can't learn to make adamantite grenade even though I have 375/375 engineering (again).

[Henhouse]

Ah, I see. I misunderstood your problem. Hm, this is rather odd. I could take a look, what is the character name?

[janusmarine]

No worries. The characters name is Orcfroy.

[Pastorblastr]

Hey Henhouse. I am aware that my professions will be reset, the problem is that I can't relearn some schematics. I.e. I can't learn to make adamantite grenade even though I have 375/375 engineering (again).

Did you goto Outland and visit Honor hold(alliance) or Thrallmar(horde) because the grenade is taught there.

[Terezi]

Hey Henhouse. I am aware that my professions will be reset, the problem is that I can't relearn some schematics. I.e. I can't learn to make adamantite grenade even though I have 375/375 engineering (again).

Did you goto Outland and visit Honor hold(alliance) or Thrallmar(horde) because the grenade is taught there.

[janusmarine]

Thanks Pastorblastr. I found the schematics at the trainer in area 52.