Smolderforge Support Community

Since I changed race on my character (Orcfroy) I have some trouble with a few schematics. I had to relearn engineering, which I've done, but I can't learn the schematics I knew before the race change. The schematics I knew from before simply don't show up at any of the trainers.

Hope some of you could look into this issue.

Well that's why we have this beginning and ending dialogue boxes when you switch races.

Hey Henhouse. I am aware that my professions will be reset, the problem is that I can't relearn some schematics. I.e. I can't learn to make adamantite grenade even though I have 375/375 engineering (again).

Ah, I see. I misunderstood your problem. Hm, this is rather odd. I could take a look, what is the character name?

No worries. The characters name is Orcfroy.

janusmarine wrote:Hey Henhouse. I am aware that my professions will be reset, the problem is that I can't relearn some schematics. I.e. I can't learn to make adamantite grenade even though I have 375/375 engineering (again).

Did you goto Outland and visit Honor hold(alliance) or Thrallmar(horde) because the grenade is taught there.

janusmarine wrote:Hey Henhouse. I am aware that my professions will be reset, the problem is that I can't relearn some schematics. I.e. I can't learn to make adamantite grenade even though I have 375/375 engineering (again).

Did you goto Outland and visit Honor hold(alliance) or Thrallmar(horde) because the grenade is taught there.

Thanks Pastorblastr. I found the schematics at the trainer in area 52.